INJECTION MOLDING ENCYCLOPEDIA
Injection Molding Encyclopedia
Find hot runner articles by industry, material, and molding defect.
Frequently Asked Questions
Find products by material
View all four productsTotal 194 articles · Current:All industries
Browse by defect, material, and industry
194 articles
Scorching and Charring: Compressed Gas Causes Material Carbonization
Dark brown or black patches with halos at part ends or weld lines that cannot be cleaned and appear consistently, caused by compressed gas heating the melt to carbonization temperatures.
Uneven Gloss: Why One Area Shows Both Shiny and Matte Spots
Distinct shiny and matte zones on the same part with clear boundaries; polishing the mold cannot resolve this.
Causes of Color Variation: Melt Temperature, Residence Time, and Purge Residue
Color variation may appear as darker areas near the gate, yellowing at the far end of the same part, or batch-to-batch mismatches that require multiple shots to stabilize after a color change. Often dismissed as "material issues," it is critical to distinguish between uniform shifts across the entire mold and localized variations.
Ejector Whitening: White marks at ejector pin locations, not gates.
Small white spots or marks with distinct edges appear at ejector pin locations on the part. This phenomenon, known as ejector whitening, is more prominent in thinner sections.
Flow Marks: Ripples from Cooling Flow Fronts
Concentric ripples appear on the product surface, typically in mid-to-rear sections or opposite the gate, creating a tactile unevenness. This defect is identified as flow marks.
Dimensional Out-of-Tolerance: Distinguish Systematic vs. Random Drift
Critical dimensions are consistently out of tolerance, batch consistency is poor, and assembly fit varies.
Warpage and Deformation: Caused by Uneven Shrinkage
Flat plates warp, long bars bend, and frames twist even when individual dimensions are within tolerance. This warpage results from uneven shrinkage.
Uneven Shrinkage: Inconsistent Contraction Within a Single Part
Within the same part, some areas shrink more than others, causing thickness variations, slight local depressions, and inconsistent overall dimensions. This condition is known as uneven shrinkage.
Assembly Interference: Fit Issues May Not Be Caused by Dimensional Errors
Snap fits fail to engage, holes misalign, or mating surfaces are too tight despite individual part measurements falling within tolerance. This issue is classified as assembly interference.
Brittle Fracture: Fracture Surfaces Reveal Failure History
Parts break during assembly or drop tests, showing flat fracture surfaces with little to no stretching. The material also snaps easily when bent by hand. This failure mode is known as brittle fracture.
Can't find the matching gate issue? Share material, part, and defect details. Our engineers will evaluate it by part.
Online selection and quote