AM SMART CONTROLLER
Dedicated dynamic gate temperature control
per-channel independent
input 220 V AC
The controlled object is the gate. The manifold and nozzle body remain powered by the conventional controller; this system only manages the short section near the gate, closest to the nozzle tip.
HOW IT WORKS
01
The heater and J-type thermocouple are positioned near the nozzle tip. The system monitors only this zone and follows the set temperature curve, while the manifold and nozzle body maintain their conventional constant-temperature supply.
02
Two versions: 4 and 8 channels, each with independent setpoint and output. Input: 220 V AC; heating output: 22 V, 300 W per channel.
03
The range is 0–400°C, determined by material and gate conditions. Settings persist after power-off and resume the same curve on restart.
04
Three safeguards: over-temperature, thermocouple break, and heater short circuit. An audible and visual alarm triggers, isolating the affected channel while leaving others operational.
05
06
Count the nozzles requiring independent control and determine if zoning is needed. For molds with multiple cavities, reserve 8 channels to avoid adding a new controller for later cavities.
AM SMART
You are welcome to share the mold layout and material grade; we will check the fit and reply with a quotation.