INJECTION MOLDING ENCYCLOPEDIA
Injection Molding Encyclopedia
Find hot runner articles by industry, material, and molding defect.
Frequently Asked Questions
Find products by material
View all four productsTotal 194 articles · Current:All industries
Browse by defect, material, and industry
194 articles
Causes of Nozzle Clogging: Premature Gate Freezing and Carbon Buildup
The previous shot was acceptable, but the next product shows short shots or incomplete filling. Inspection reveals material frozen at a specific hot runner gate, blocking flow. This is most problematic in multi-cavity molds: only one or two of dozens of nozzles clog, making it hard to detect without inspection and resulting in defective batches before discovery.
Gate Carbonization: Black-Brown Layers and Specks
Black specks and inconsistent flow indicate a hard, brittle black-brown layer forming inside the gate. Carbonization accumulates gradually as material coats the gate wall and degrades under repeated heating cycles.
Gate Freezing and Cold Material: Temperature, Cycle Wait Time, and Shutdown Residue
Sudden short shots or reduced output signal gate freezing; dark hard marks after restart indicate cold material. Both issues originate at the nozzle tip but stem from different causes.
Valve Pin Sticking and Poor Closure: Drive, Timing, and Gate Fit
Two common issues in valve-gate hot runners are: residual material or stringing at specific gates due to poor closure, and delayed actuation causing fill sequence variations or short shots due to sticking.
Hot Runner Leakage: Joint Faces, Preload, and Fit Clearance
Resin rings appear on the mold face, and flash-like overflow consistently occurs at a single location. Inspection confirms leakage from the hot runner/manifold joint or gate bushing interface, not the cavity.
Temperature Control Issues and Runaway: Thermocouples, Zones, and Power
Symptoms include consistent short shots or yellowing despite correct setpoints, or temperature fluctuations synchronized with mold opening and closing. These indicate circuit issues rather than simple offset errors.
Gate Whitening: Shear, Stress, and Ejection
Foggy whitening or stress marks near the gate that worsen toward the entry point and cannot be polished away, resulting in cosmetic rejection.
Gate Residue and Protrusion: Break-off Timing, Hole Size, and Valve Pin
Protrusions, residual rings, or shear marks at the gate lead to assembly fit issues and require trimming for cosmetic parts. This is known as gate residue.
Gate Wear and Corrosion: Increased Diameter Affects Break-off
After prolonged use, gate diameters exceed drawing specifications, making clean break-off difficult and causing streaks. Glass-filled or flame-retardant materials can also lead to internal pitting corrosion.
Causes of Short Shots: Gate Temperature, Flow Length Ratio, and Incomplete Filling
Missing sections at the far ends or in thin walls indicate short shots (incomplete filling). Unlike clogged nozzles, which stop flow entirely, short shots occur when the melt halts mid-fill. Identify the root cause before troubleshooting.
Can't find the matching gate issue? Share material, part, and defect details. Our engineers will evaluate it by part.
Online selection and quote