MATERIAL TOPIC
PA46
PA46 crystallizes rapidly; inadequate gate and runner temperature control can cause cold slugs, short shots, and dimensional variations.
0 articles
Articles in this topic
View all articlesHot Runner Leakage: Joint Faces, Preload, and Fit Clearance
Resin rings appear on the mold face, and flash-like overflow consistently occurs at a single location. Inspection confirms leakage from the hot runner/manifold joint or gate bushing interface, not the cavity.
Which Molding Projects Suit FHFC Hot Runners? Four Key Checks
FHFC hot runners are not suitable for every molding project. This technology controls local gate temperature to address stringing, drooling, and clogging. It is not a whole-mold FHFC solution and does not resolve weld lines, surface appearance, or warpage. Material selection, part design, existing defects, and production volume provide the initial basis for assessment.
Can't find the matching defect? Share photos of the resin, shot weight, and gate for a review against the actual structure.
Online selection and quote