INJECTION MOLDING ENCYCLOPEDIA
Injection Molding Encyclopedia
Find hot runner articles by industry, material, and molding defect.
Frequently Asked Questions
Find products by material
View all four productsTotal 194 articles · Current:All industries
Browse by defect, material, and industry
194 articles
Insufficient Weld Line Strength: Visible Seams Indicate Weakness
Weld lines may not be visually obvious, but parts consistently fail along these lines under stress, indicating insufficient weld line strength.
Stress Cracking: Delayed Failure Is No Coincidence
Parts appear normal upon ejection but develop cracks after several days or when exposed to solvents, with cracks initiating at gates or corners. This phenomenon is known as stress cracking.
Degradation-Induced Brittleness: Irreversible Damage from Extended Residence Time
Products show darkened colors, significantly reduced mechanical properties, and increased brittleness. Switching machines resolves the issue for the same material grade, indicating degradation-induced brittleness caused by prolonged residence time.
Mold Sticking and Scuffing: Surface Damage During Demolding
Parallel stripes appear on the side walls along the demolding direction; severe cases involve surface layer removal and material residue on the mold. This defect is classified as sticking and scuffing.
Ejection Deformation: Distortion from Ejector Pins
Ejector pins cause depressions or protrusions, leading to part warping or bending that sets during cooling. This is known as ejection deformation.
Mold Deposits: Persistent Residue on Mold Surfaces
After days of continuous production, brown or white residue forms on cavity surfaces, causing spots and haze on parts. This is mold buildup.
Poor Venting: Trapped Air Leads to Multiple Defects
Short shots at the end, burnt weld lines, and surface marks all appear in the last-filled areas. This typically indicates inadequate venting.
Open-Nozzle Hot Runners in Connector Molding: LCP vs. PA9T Field Test
Stringing and drooling in connector injection molding are typically addressed through machine tuning and post-processing. This field test compares open-nozzle hot runners with active temperature switching against constant-temperature runners in LCP and PA9T, focusing on gate condition and yield.
AM Industry: One Focus – FHFC Hot Runners for Stringing, Drooling, and Clogging
For LCP, PA6T, PA9T, and PPS molding, gate stringing, drooling, and clogging often persist despite machine adjustments. AM Industry specializes exclusively in FHFC hot runners with dynamic gate temperature control. This article explains how this approach differs from mold RHCM, why we focus solely on this challenge, and when an upgrade may not be worthwhile.
AM Industry: FHFC Hot Runner Manufacturer with Swedish Core Technology
AM Industry's Shenzhen office manages commercial and technical coordination, while its Dongguan facility handles manufacturing. On-machine validation is conducted with specialist partners throughout the Pearl River Delta. Our focus is high-temperature molding for precision connectors, covering gate evaluation, material selection, system design, validation follow-up, and mass-production optimization.
Can't find the matching gate issue? Share material, part, and defect details. Our engineers will evaluate it by part.
Online selection and quote